How to eliminate problems with radiant system loops: Difference between revisions

Latest revision as of 15:52, 26 July 2016

Problems associated with automatic generation of loops drawings.

@@ Line 16: / Line 16: @@
 }}
 ==Problem description==
-Problems associated with automatic generation of pipe feeds using the ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' tool are diagnosed by means of the following message:
+Problems associated with automatic generation of loops drawings.
-* '''''<IS_TS id=strErrNieUdaloSieUlozycPrzylaczy/>'''''.
-The message informs that pipe feeds could not be generated automatically by means of the ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' tool, due to the following reasons:
-* specified or automatically sized arrangement spacings are too large,
-* manner of component crossing ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' is inappropriate (for the algorithm of automatic pipe feed arrangement),
-* number of component crossings ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' is too large,
-* ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' components are located too close to each other,
-* width of the strip within which ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' generates pipe feeds is too small or too large (reaches beyond the borders of the heating zone).
 ==Solution==
-* Specify smaller pipe feed arrangement spacing.
+* Change pipe feed arrangement spacing.
-{{#ev:youtube|B0aVny2-vUw|900||||rel=0}}<br/>
+{{#ev:youtube|XRRDxWBxU_M|900||||rel=0}}<br/>
 [[Category:TYPICAL PROBLEM]]
 [[Category:InstalSystem 5]]