How to create the roof multifaceted: Difference between revisions

Revision as of 14:26, 3 November 2016

Multifaceted roof create using Add roof edge.
Icon of component is available in the 2D Editor window on the Main tools bar in the Construction section when the Construction editing scope is enabled.
1. Add roof edge
The program highlights in red edge of the roof, which is diagnosed impossible to present in 3D view.

Use the AUTO and ORTO modes.

@@ Line 21: / Line 21: @@
 ==Solution==
-* Specify smaller pipe feed arrangement spacing.
+Use the ''AUTO'' and ''ORTO'' modes.
-{{#ev:youtube|B0aVny2-vUw|900||||rel=0}}<br/>
+{{#ev:youtube|us6xceXY_XA|900||||rel=0}}<br/>
-* Change manner of ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' component arrangement.
-{{#ev:youtube|pAcWrZ2mJR8|900||||rel=0}}<br/>
-* Increase width of ''<IS_TS id=iNameOPStrefaPrzylaczy/>'' component arrangement area.
-{{#ev:youtube|BXGQr_6KRwE|900||||rel=0}}<br/>
-* Draw pipe feeds manually.
-Depending on design circumstances, or when pipe feeds cannot be generated automatically, the tool for manual arrangement of pipe feeds can be used.<br/>{{Info}} [[Editing pipe feeds in a radiant system#Example of use|Manual pipe feeds editing]].
 [[Category:TYPICAL PROBLEM]]
 [[Category:InstalSystem 5]]