InstalSystem 5: Difference between revisions
Jump to navigation
Jump to search
| Line 50: | Line 50: | ||
* [[How to eliminate problems with the diagnostic message: "Automatic division of H/C Zone not possible"]] | * [[How to eliminate problems with the diagnostic message: "Automatic division of H/C Zone not possible"]] | ||
* [[How to make the program run faster]] | * [[How to make the program run faster]] | ||
Revision as of 14:50, 22 June 2017
Product information
Software applications
- Introduction to the work with the package InstalSystem 5
- Calculation of cooling capacity for radiant systems (floor, wall or ceiling)
- Calculation of design heat load of rooms
- Designing heating systems with convective radiators
- Designing radiant (ceiling, wall) panel heating/cooling systems
- Design of radiant heating floor and wall installation
- Designing of radiant heating installation on the basis of data from the Smart application
- Designing radiant heating systems with pipe-runs as distribution system
- Quick design of radiant heating/radiant cooling
- Radiant steel ceiling panels
- Smart application - Quick selection of system components
Sample projects
- Installation with ceiling heating and cooling system in commercial building
- Installation with underfloor and wall radiant heating system in single family building
Functionalities
- Appending drawings with radiant system loops
- Combine base files
- Connecting storeys with the "Stack" element
- Editing pipe feeds in a radiant system
- Export / print results and drawings
- General data
- Heating/cooling zone
- Import files
- Installation, activation and update InstalSystem 5 package
- Manifold and accessories
- Preparation of building structure
- Presentation of the calculations result
- Project and application management
- Search components in the project
- Software configuration
- Using catalogs and catalogs data in the project
- View navigation in the graphical editor
Typical problems
- How to calculate a file using a package configuration other than the one under which the file was created
- How to eliminate problems with the diagnostic message: "Automatic arrangement of pipe feeds not possible - change pipe feeds route or H/C Zone parameters or arrange pipe feeds manually"
- How to eliminate problems with the diagnostic message: "Automatic division of H/C Zone not possible"
- How to make the program run faster